This section focuses on the processing and storage of raw materials.
• Raw materials (silica sand or fly ash, cement, lime, gypsum, aluminum powder) are stored and prepared according to the recipe.
• Precision metering and mixing systems are used to ensure consistent quality.

This section is responsible for fabricating steel mesh (cage) required for the panels, as well as manual or automatic mesh hanging and the automatic circulation of the assembly frame.

In this section, raw materials are mixed into a pouring mixer and then poured into mould. During the production, the steel mesh is inserted into the slurry by pin-inserting hoister, and the mould is transported to the pre-curing room via a ferry cart. The slurry will form into the green cake by foaming and hardening. Subsequently, the mould transports the green cake to the cutting section by pre-curing ferry cart, withdrawing the inserted mesh holding beans at the same time.

This is the core section during the AAC block and panel production. The mould with green cake is demoulded by tilting hoister, and the green cake along with side plate are placed on a cutting cart, shaped through the process of profile cutting, horizontal cutting and vertical cutting. Bottom waste is removed by tilting table and scraper, then recycled. At last, the green cake is loaded by hoister and ferry cart.

• 
• 
• 

The grouped green cakes are sent into the autoclave for constant pressure curing by traction mechanism and ferry carts. Once the autoclaving is completed, the products will be pulled out of the autoclave by the ferry cart and transported to the finished products packing section.

• 
• 
• 

This section handles the sorting, stacking, packaging, and transportation to storage yard of white cakes, which have been separated after autoclave.

• 
• 
•