Hardware redundancy of safety, collision-proof and in-place signals is set at the front and rear end of each section to ensure continuous and safe operation;
P+F background control switch is suited to signals reception of different colors on target surface.
Mis-transmission or interference signal in the software special editing processing, software redundant editing;
Intelligent mesh cart dislocation of automatic cycle positioning, to solve the overload of fast moving equipment with different inertia of the parking impact, to correct resistance change indeterminacies which caused by mechanical structure.
DCS automation control system is composed of Siemens PLC hardware, that is decentralized control and centralized management mode, with characteristics of low failure rate and easy maintenance.
All devices with the decentralized control system are equipped with on-site local control system, which can independently operate and monitor the machine in real time. Even one fails (manual intervention operation), the others can run normally. Compared with other brands (one point failure will cause the whole system stop), our system can quickly solve problems, resume normal production, and avoid heavy losses caused by waste cakes.
Centralized management mainly realizes through the combination of industrial Internet, field bus and AMES system information sharing. The system provides real and accurate historical data recording and intelligent management of device operation, fault diagnosis and remote operation and maintenance. Compared with other brands, we took the lead in developing remote intelligent operation and maintenance system for AAC production, providing timely and effective production information and remote service to all the customers.
Empower Every Teeyer, Make Teeyer Renowned Globally!
